WPM Logo

Walser

Pistenraupen
Modellbau

DE

Mechanical Blade Lifting

There are in principal two mechanical solutions available for a scale front attachment unit which are using the lifting cylinder directly and thus eliminate unsightly leverage systems: the piston rod can be connected directly to the servo with a joint, or indirectly with a lever like at the Pistenking models. We built a fake extension of the tub for our PB600 on Graupner chassis. The fulcrum of the lever would be outside of the Graupner tub, and two long slots would be necessary in the tub, which we didn't want.


Therefore we built the first solution with a directly connected piston rod. A slot has to be milled into the piston rod, so that it is hold in position by the bolt. This slot weakens the rod, which is also strained by a bending moment at this point. We therefore chose steel, and a short calculation showed a maximum deflection of 0.3 mm, which is absolutely acceptable.


The lifting cylinder has to be open for the piston rod at the upper end. This eliminates the usual connection with a ball joint. To keep it in place a small brass bracket is glued to its side. This will hardly be noticed later on, after being painted black and mounted on the inner side.

Steel piston rod with milled slot

Lifting cylinder

The following pictures show the front attachment unit in the lowered and raised position, as well as the corresponding servo positions. After everything is painted black, the trick with the extended pistonrod is hardly visible.


Copyright © 2019 Walser Pistenraupenmodellbau 

Copyright © 2011-2024 Walser Pistenraupenmodellbau 

Diese Seite verwendet Cookies. Sie stimmen der Verwendung von Cookies durch Anklicken von “OK” zu. Nähere Informationen finden Sie in unseren Datenschutzbestimmungen.
This page is using Cookies. You are permitting the use of cookies by clicking on “OK”. More information can be found at our Privacy Protection.

OK